At this point, increased downtime and - if the mating.
Mar 04, Video is a brief how-to guide on assembling and then removing a taperlock bushing type pulley from a shaft.
You can do this by consulting the table below.
The first step in removal is to loosen and remove all screws or bolts from your assembly. Once separated, take and thread them into the removal holes in the bushing. Alternately tighten to remove the bushing. If either the QD or split-taper bushing is challenging to remove, place a wedge between the bushing flange and component stumpcutter.barted Reading Time: 4 mins.
One other item worth mentioning: Do not assume that the bolts and threaded holes are the same!
Jul 23, The FACE of the bushing (top most in this picture) is installed nearest to the end of the shaft so it is easy to use the jacking bolts and easily remove the pulley. Simply remove these bolts and then install the jacking bolts. In the photo you can see that the bushing is NOT brought in tight against the pulley. To Remove QD Type Bushings 1. Loosen and remove all mounting bolts.
2. Insert cap screws into all threaded jack screw holes. 3. Loosen the bushing by first tightening the screw furthest from the bushing saw slot, then, alternately tighten remaining screws. Keep tightening the screws in small but equalFile Size: KB.