Another thing of note is that the bulbs are a larger diameter than.
Jul 28, You will need a small screwdriver to remove the fuse cover. Then you can replace damaged fuse. Be on the lookout for strands of lights on the tree. A number of them are numbered alphabetically. So remove the unlit section’s end plug by finding the plug at its end. Connect the new lights to the tree and wrap them around it. Nov 12, How to remove the lights from a prelit tee. How to remove the lights from a prelit tee. Nov 24, Pre-lit Christmas Tree Lights Repair/Replace When I unpacked the tree this year, I knew that I had a project ahead of me.
My tree was still in very good shape, but the plus lights were shot. I guess I could have just bought a new pre-lit tree, but mine cost a pretty stumpcutter.barted Reading Time: 6 mins. Method: Firstly, you have to make sure that you have to plug the pre-lit Christmas tree into a workable power outlet supply. If you have your own Christmas bulb tester, it is recommended that you check each of the lights.
You need to do this Whenever you notice any one of the bulbs is not. Most prelit trees have fuses inside the electrical plugs. Double-check that the tree is unplugged from the wall and then check each plug and connector for a blown fuse. Unplug the cord from the wall. Open the fuse cover on top of the plug by sliding the cover toward the blades or prongs. Step 2. Pull off the top segment of the pre-lit tree. Most pre-lit trees will have three sections and the top section should be rather small and light.
Remove by twisting back and forth slightly to loosen the connection.
There may be small light connectors between each tree segment. Unplug these after you've loosened the top segment of the tree. Dec 06, Now, that the white bulb base is exposed, you can grab it and wiggle it loose. It might get a bit mangled using needle nose pliers, but that's fine. Remember, they are probably glued, so it takes a bit of work to loosen it. When it's loose, take it stumpcutter.barted Reading Time: 3 mins.